How to Wrap with Tenugui
With its unique and beautiful colors and patterns, tenugui is perfect for gift wrapping, as well as for wrapping lunch boxes and plastic bottles. On this page, we will clearly explain how to use tenugui as a wrapping cloth with the help of illustrations.
How to tie Tenugui
Basic Knot: Tying a square (reef) knot
- Follow the tying process
-
-
1.

Put the right side (or left side) on top and cross over the oter side.
-
2.

Tie in a knot.
-
3.

Cross them with the left (or right) side on top.
-
4.

Tie again.
-
5.

Pull both ends.
-
6.

Shape and it’s done.
-
How to Wrap with Tenugui
#01.How to Wrap a Wine Bottle
Tenugui"Maiko walking through shrine gates"
- Follow the tying process
-
-
1.

Spread out the tenugui face down and lay the wine bottle on it.
-
2.

Place the end of the tenugui over the bottle, slightly below the shoulders, and wrap it around both sides of the bottle as shown in the picture.
-
3.

Wrap it tightly and the finish will be beautiful.
-
4.

Hold the bottle with one hand, twist the left-over material in the same direction as it was wound.
-
5.

Make a loop by circling the twisted part around the shoulder of the bottle then pull it through and out from under the loop.
-
6.

Shape it and it's done.
-
#02.How to Wrap a Plastic Bottle
■Basic wrapping
Tenugui「Bamboo forest and Green maple leaves」
- Follow the tying process
-
-
1.

Fold the tenugui to twice the length of the plastic bottle.
-
2.

Stand the bottle up in the center.
-
3.

Wrap the tenugui tightly and spread it so that the tip of the hem is sharp.
-
4.

Tilt the bottle toward the front (side of the spread hem).
-
5.

Tie up both remaining sides.
-
6.

Shape it and it's done.
-
■Wrap in a kimono-like shape
Tenugui"Maiko's Japanese hairpin Spring"
- Follow the tying process
-
-
1.

Fold the tenugui to twice the length of the plastic bottle.
-
2.

Place the bottle upright in the center.Fold the top back about 1 cm.
-
3.

Treat the folded part as the collar of a kimono and wrap it so that the right side (as seen from the front) is on top.
-
4.

Fold up the spread hem.
-
5.

Fold back about 2 cm to make it look like a kimono obi.
-
6.

Tie the ends of the folded part at the back.
-
7.

Shape it and it's done.
-
#03.How to Wrap a Lunch Box
- Follow the tying process
-
-
1.

Fold the tenugui into the appropriate size.(roughly in half)
-
2.

Place the lunch box diagonally in the center
-
3.

Hold one corner and wrap it to cover the lunch box.
-
4.

Wrap the other corner in the same way.
-
5.

Lift up both ends while adjusting, and tie in the middle.
-
6.

Shape it and it's done.
-
#04.How to wrap tissue
- Follow the tying process
-
■How to wrap a tissue box
-
1.

Fold both ends of the tenugui into an appropriate size.
-
2.

Place the tissue box on the center.
-
3.

Fold up both sides tight to the sides of the tissue box.
-
4.

Fold up the top and bottom of the box to form a boat-like shape while fixing the ◆ (around the tissue outlet) in the figure.
-
5.

Tie both ends together. First, make a loose knot on one end, then tie the other end tightly. Finally, go back and tighten the first knot to keep everything in place.
-
6.

Shape it and it's done.
■How to make a pocket tissue case
-
1.

Fold both ends of the tenugui so that its length becomes about 55 cm.
-
2.

Place the tissue along the edge of the tenugui and fold the other end to the height of the tissue.
-
3.

Put the pocket tissue next to the tenugui, and fold the other end up.
-
4.

Hold the front part, and turn it over with the back facing up.
-
5.

Fold the left and right sides to fit the width of the pocket tissue.
-
6.

Put the pocket tissue next to the tenugui, and fold it once toward you so it lines up with the height of the tissue.
-
7.

Tuck the extra part inside and neaten up the shape.
-
8.

Open the ◆ in the diagram (the part with the opening), place the pocket tissue inside, and done.
-
#05.How to make a Book Cover
- Follow the tying process
-
-
1.

Fold both ends of the tenugui to about 2.8 times the length of the book.
-
2.

Lay the book on the tenugui, with the spine aligned to the vertical center.
-
3.

Fold the tenugui in half lengthwise to cover the book. Then, fold it back to match the width of the book. Do the same on the other side.
-
4.

Spread it out so that the folded part is at the back.
-
5.

Move the book to the side, and fold the top and bottom to match its height.
-
6.

Flip the first folded side, then tuck the second folded side inside and finish the shape.
-
7.

Put the book in and it's done.
-

























